EXCELiner
EXCELiner is available in 4, 3, 2 and 1 lengths. EXCELiner components fasten together with 100% stainless steel pop rivets wich are supplied with the liner. The holes and slots for the rivets are factory pre-punched so no drilling is required. The male and female ends are hemmed to make the liner more rigid and reduce the likelihood of cutting yourself during installation.
Slip lengths are available in 4 and 1 lengths. Slip lengths are used to adjust the length of the system without cutting. Note: Slip lengths must be installed above a fixed length or they will not adjust. They should not be installed immediately above a support, tee or elbow.
The flange for the tee mouth is formed into the vertical tee body to provide a strong connection while minimizing projection to facilitate installation in tight flues. The tee mouth fastens to the body with heavy duty stainless steel screws which install through the inside of the mouth.
The LTA eliminates the difficult job of cutting and fastening a short horizontal length of liner in the breeching. The horizontal length adjusts from 9 3/4 to 15 3/4.
Designed to connect EXCELiner to a flexible liner where the rigid liner is installed below the flexible liner. It can be also used to connect a flexible liner to an appliance collar. Note: The EXCELiner male end will fit into most brands of flexible liner (except for some models of flex which are intentionally made undersize) so no adapter is generally required when the flex is installed below the rigid.
Designed to increase the size of an EXCELiner to accommodate a range of flue sizes, appliances and installations. Note: Increasing chimney size can have a negative impact of chimney performance and safety. Use these components only when appropriate.
The ITH is tested and listed to connect through a combustible wall into a masonry chimney. It is adjustable to accommodate wall thicknesses up to 10.
EXCELiner rain caps are made entirely of type 304 stainless steel. The rain cap top is held in place with four wing nuts so it can be removed easily for cleaning without the need to remove the rain cap itself. Deluxe model has a stainless steel band. The optional EXCEL stainless steel spark screen (ERCS) can be installed if required.
The top support is designed to seal off the top of the liner system and support the vertical liner. It is available in either stainless steel or galvalume. There are two base sizes available - 16 X 16 and 24 X 24.
The base support is designed to seal and support a liner system. It is available in galvalume only.
Designed to decrease the size of an EXCELiner to accommodate a range of flue sizes, appliances and installations. Note: Decreasing chimney size can have a negative impact of chimney performance and safety. Use these components only when appropriate.